Iowa DOT CDL General Knowledge Practice Test 9
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. Which steering system findings count as defects during the inspection?
Show answer
Answer C: Bent, loose or broken column parts, arms, drag links or tie rods, and missing nuts, bolts or cotter keys
Every joint and fastener between the steering wheel and the tires carries the driver commands, so looseness or a missing retainer can end in a complete loss of steering.
-
2. You are the first to arrive at a crash. What is the correct order of actions?
Show answer
Answer C: Protect the area, notify the authorities, care for the injured
Preventing a second crash comes first, because an unprotected scene puts the injured and the helpers in more danger than the original collision.
-
3. You are about to back across a quiet street into a driveway. Which of these is good practice before you start to move?
Show answer
Answer B: Turn on the four-way flashers and sound the horn to alert anyone nearby
Warning other road users and pedestrians before a reverse maneuver gives them the chance to stop or move clear before the vehicle starts back.
-
4. How much free play in the steering wheel is enough to make a vehicle hard to steer and should be reported?
Show answer
Answer B: More than 10 degrees, roughly 2 inches of movement at the rim of a 20 inch wheel
Excess play means steering input is lost before the wheels respond, and more than about 10 degrees is treated as a defect.
-
5. What should you check about the air hoses and the electrical cord running to the trailer?
Show answer
Answer D: That they are free of damage, properly connected and not dragging or rubbing
Lines that chafe on the frame or drag on the road wear through, and a broken line takes away trailer braking or trailer lighting without warning.
-
6. You are on a freeway and see brake lights come on in several vehicles far ahead of you. What should you do?
Show answer
Answer A: Ease off the accelerator and get ready to slow down
Brake lights well ahead are an early warning that traffic is slowing, and acting on them gives a heavy vehicle the room it needs.
-
7. With the tractor coupled to the trailer, what should you see between the upper and lower fifth wheel plates?
Show answer
Answer A: No space at all between the two plates
Any daylight between the plates means the trailer is not properly seated on the fifth wheel and the coupling can come apart under load.
-
8. What are you checking when you pull the engine oil dipstick during the pre-trip?
Show answer
Answer A: That the oil level is within the safe operating range marked on the stick
The dipstick shows whether there is enough oil to lubricate and cool the engine, and a level outside the safe range must be corrected before driving.
-
9. Why should a driver avoid traveling alongside another vehicle for any length of time?
Show answer
Answer D: You lose your escape route and you may be sitting in the other driver blind spot
Running beside someone leaves nowhere to move if you have to change lanes, and the other driver may not know you are there at all.
-
10. Which drivers does the Iowa DOT list as exempt from holding a CDL in Iowa?
Show answer
Answer B: A farmer or a person working for a farmer operating a properly identified covered farm vehicle
The Iowa DOT Commercial Driver's License Quick Guide lists covered farm vehicle operators, firefighters and peace officers on emergency duty, active duty military drivers, recreational vehicle operators, and in-home care aides among those exempt from holding an Iowa CDL.
-
11. What does the suspension system weight rating tell the driver?
Show answer
Answer A: The maximum weight that the manufacturer says the suspension can carry
Like tires and axles, suspensions have a manufacturer capacity, and loading beyond it can damage springs and air bags.
-
12. What is the driver looking for when the exhaust system is inspected?
Show answer
Answer B: Loose, broken or missing pipes, brackets or clamps, and signs that exhaust is leaking
A loose or leaking exhaust system can send carbon monoxide into the cab and can put hot gas against parts that will burn.
-
13. An intermodal container is being carried on an ordinary flatbed rather than on a container chassis. What does that mean for securement?
Show answer
Answer B: It must be secured with tiedowns that meet the container securement requirements
A container carried on a vehicle that is not fitted with integral locking devices has to be secured to the deck with tiedowns that satisfy the rules for containers.
-
14. Before raising the hood to inspect the engine compartment, what should you do?
Show answer
Answer B: Shut off the engine, set the parking brake and chock the wheels if needed
The engine compartment is inspected with the engine off and the vehicle secured so nothing can move or turn while your hands are inside.
-
15. How should the headlamps be checked during the pre-trip inspection?
Show answer
Answer A: By switching on both low beam and high beam and confirming each one works outside
Both beams are separate circuits, so each is switched on in turn and confirmed from outside the vehicle where the lamps can actually be seen.
-
16. Your brakes are starting to fade on a mountain downgrade and a sign shows an escape ramp one mile ahead. What should you do?
Show answer
Answer B: Plan to use the ramp instead of trying to reach the bottom
Fading brakes on a grade only get worse, and the ramp exists precisely so a driver does not have to gamble on the rest of the descent.
-
17. An overpass you have driven under before now has a fresh layer of pavement on the road below it. Why does that matter?
Show answer
Answer B: The new layer raises the road and reduces the clearance
Repaving lifts the road surface, so the real clearance under a structure can be less than the height posted on it.
-
18. Why should high beams not be used in fog?
Show answer
Answer A: The light reflects back off the droplets and blinds you
Fog is made of water droplets that scatter light straight back at the driver, so a stronger beam makes the wall of glare worse rather than better.
-
19. How far ahead can a driver see with low beams and with high beams?
Show answer
Answer C: About 250 feet with low beams and about 350 to 500 feet with high beams
Low beams reach roughly 250 feet and high beams roughly 350 to 500 feet, and speed at night has to stay inside the distance the lights really show.
-
20. Where on the road are you most likely to find ice in cold weather?
Show answer
Answer B: On bridges, overpasses and shaded stretches, which freeze before the rest of the road
Bridges and overpasses lose heat from above and below, and shaded areas get no sun, so they ice over first and stay icy longest.
-
21. What color must the clearance and side marker lamps and reflectors at the front of a trailer be?
Show answer
Answer A: Amber
Amber marks the front and the forward part of the sides of a vehicle, while red marks the rear, so another driver can tell which way the vehicle is facing.
-
22. Your axle weights are legal, but the tires on that axle are rated below the weight it is carrying. What controls?
Show answer
Answer B: The lower figure, so the tires may not be loaded beyond their marked rating
You may never exceed the rating marked on a tire, even when the axle limit would allow more, because an overloaded tire builds heat and can fail.
-
23. How should a driver use brakes fitted with an antilock system during an emergency stop?
Show answer
Answer C: Brake as usual and keep enough pressure to stay in control while steering around the hazard
The system only works when the brakes are applied hard enough for it to act, so the driver keeps pressure on and steers while the system prevents lockup.
-
24. Why does the manual insist on a firm grip with both hands on opposite sides of the steering wheel?
Show answer
Answer A: A hard bump can pull the wheel out of a loose grip
Hitting a curb or a deep pothole can jerk the wheel violently, and only a firm two-handed grip keeps the vehicle under control when that happens.
-
25. The coolant temperature gauge climbs above its normal range on a long grade. What is the correct response?
Show answer
Answer C: Stop when it is safe to do so and find the cause before going on
Rising coolant temperature signals a fault such as a lost belt, a leak or a blocked radiator, and continuing can turn a repair into a destroyed engine.
-
26. What does the gross vehicle weight rating of a vehicle describe?
Show answer
Answer A: The maximum loaded weight of that single vehicle, as specified by the manufacturer
The rating is the manufacturer figure for the loaded weight of one vehicle, so it is a limit fixed in advance rather than a measurement of the load on board today.
-
27. For an unblocked article longer than 10 feet, the minimum is two tiedowns plus how many more?
Show answer
Answer B: One more for every additional 10 feet of length or any part of 10 feet
Past the first 10 feet, one more tiedown is added for each additional 10 feet of length or any fraction of that distance.
-
28. After coupling, where should the fifth wheel release handle be?
Show answer
Answer A: In the locked position with the safety latch in place
The handle must be pushed in and latched, because a handle left out means the jaws can open and release the trailer while you are driving.
-
29. Why can an empty truck need a longer stopping distance than a loaded one?
Show answer
Answer C: An empty vehicle has less traction, so its wheels lock up more easily
Brakes and tires are designed for a loaded vehicle, and with little weight on the axles the tires grip less and lock sooner.
-
30. You must leave the vehicle parked on a slight grade. What adds security beyond setting the parking brake?
Show answer
Answer D: Chocking the wheels so the vehicle cannot roll if the brake bleeds off
Chocks hold the vehicle mechanically and are the standard backup whenever a parked vehicle could roll.
-
31. Cargo falls from your trailer and causes a crash behind you. Who is likely to answer for it?
Show answer
Answer C: The driver and the carrier, since securing the load on the road is their duty
Whoever loaded the vehicle, the driver and the carrier are responsible for the load being secure while it is on the road.
-
32. What is normally required in order to move an over-width or over-length load?
Show answer
Answer B: A special permit along with warning devices such as flags and signs
Oversize movements need a permit plus marking devices, and travel is often limited to certain hours or routes.
-
33. The scale shows that your combination is over the legal gross weight. Why will sliding the tandems not fix it?
Show answer
Answer B: Because sliding the axles changes where the weight sits, not how much there is
Repositioning axles redistributes weight between axle groups; when the total is too high, freight has to come off the vehicle.
-
34. What does the gross combination weight rating cover?
Show answer
Answer B: The maximum loaded weight of the power unit together with the trailer or trailers it tows
The combination rating takes in the power unit and everything behind it, loaded, as specified by the manufacturer.
-
35. You are backing a tractor-trailer in a straight line and the trailer starts to drift to the left. What is the standard correction?
Show answer
Answer D: Turn the top of the steering wheel a little to the left, toward the drift
Small corrections made in the direction the trailer is drifting bring it back into line; large or opposite movements make the drift worse.
-
36. Which parts of total stopping distance can a driver shorten simply by staying alert and looking far ahead?
Show answer
Answer B: Perception distance and reaction distance
Alertness shortens the time spent recognizing a hazard and moving your foot to the pedal; braking distance depends on speed, weight, brakes and the road surface.
-
37. Compared with a fully loaded one, an empty truck under hard braking will often do what?
Show answer
Answer A: Need a longer distance to stop because traction is poor
Stiff suspension and little weight over the tires reduce grip, so the wheels lock early and the vehicle can take longer to stop.
-
38. Cargo securement must be strong enough to hold the load under which conditions?
Show answer
Answer A: Hard braking, hard acceleration and hard turning, as well as the bouncing of the road
The securement standard is written around the forces of a hard stop, a hard start, a hard turn and vertical movement on a rough surface, all of which occur in ordinary driving.
-
39. An article of cargo has been blocked so that it cannot move forward. How many tiedowns does the federal rule call for?
Show answer
Answer A: One tiedown for every 10 feet of article length, or any part of that
Blocking against forward movement lowers the requirement to one tiedown per 10 feet of length or fraction of 10 feet.
-
40. Why does a driver use pull-ups while backing into a tight space?
Show answer
Answer C: To pull forward and start the approach again when the angle is going wrong
Stopping, pulling ahead and repositioning fixes a bad angle safely, and there is nothing wrong with needing more than one attempt.
-
41. You must drive well below the speed of surrounding traffic, for example when climbing a steep grade with a heavy load. What should you do?
Show answer
Answer B: Turn on the four-way flashers to warn following traffic, where state law allows it
Flashers warn faster traffic that a slow-moving vehicle is ahead, which helps prevent rear-end crashes; some states restrict their use while moving, so check the local rule.
-
42. You are dropping a loaded trailer in a yard. How far should the landing gear be lowered?
Show answer
Answer A: Until the pads make firm contact and the trailer weight is just off the fifth wheel
Cranking down until the gear is firmly on the ground and just lifting the load off the fifth wheel makes the trailer stable and lets the tractor pull out cleanly.
-
43. Which of these is a suspension defect you must look for during the walkaround?
Show answer
Answer D: Cracked or broken spring leaves, loose or broken U-bolts, or leaking air suspension bags
Broken springs, failed U-bolts and leaking air bags let the axle shift or the body drop, which can make the vehicle impossible to control.
-
44. On a wet road, a commercial driver should reduce speed by roughly how much?
Show answer
Answer C: By about one third
Cutting speed by roughly a third, for example from 55 to about 35 mph, restores a margin for the traction lost on a wet surface.
-
45. Why is driving much slower than the rest of the traffic dangerous?
Show answer
Answer B: Other drivers must keep passing you, which creates conflicts
Traffic that has to work its way around you produces lane changes and closing speeds, which is why a large speed difference is itself a hazard.
-
46. How are the headlights, marker lights and turn signals checked during the seven-step inspection?
Show answer
Answer A: The engine is shut off, the parking brake is set, the lights are switched on and then checked from outside the vehicle
The lights are switched on with the vehicle secured, then the driver walks around and confirms each lamp actually works and is clean.
-
47. Which items belong to the in-cab part of the inspection?
Show answer
Answer D: Gauges, controls, mirrors, windshield, wipers, horn, heater and defroster
The in-cab step checks the instruments and controls the driver depends on, along with mirrors, glass, wipers, horn and the heater and defroster.
-
48. Which combination of warning devices meets the requirement for a stopped commercial vehicle?
Show answer
Answer A: Three reflective triangles, or six fusees, or three liquid burning flares
A vehicle may carry three bidirectional reflective triangles, six fusees or three liquid burning flares as its warning devices.
-
49. The paperwork shows a weight, but the load looks heavier than you expected. What should you do?
Show answer
Answer C: Weigh the vehicle, since you are the one answerable for driving it overweight
The driver is the one who can be cited for an overweight vehicle, so a doubtful weight is settled on a scale before the trip continues.
-
50. What must the driver confirm about the required emergency equipment before a trip?
Show answer
Answer A: That it is in place, in working order and ready to be used
Federal rules require the driver to be satisfied that the emergency equipment is present and ready, because it is needed at the worst possible moment.