Iowa DOT CDL General Knowledge Practice Test 6
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. What are you looking for on the brake drums during the walkaround?
Show answer
Answer B: Cracks, dents and any oil or grease that has reached the friction surface
A cracked or badly scored drum can break apart under braking heat, and oil or grease on the friction surface destroys the braking effort at that wheel.
-
2. When speed doubles, what happens to braking distance?
Show answer
Answer D: It becomes roughly four times as long
Braking distance rises with the square of speed, so twice the speed needs about four times the distance to stop.
-
3. A strap runs from an anchor point on one side of the trailer, over the load, and down to an anchor point on the opposite side. How much of its working load limit counts toward the total required?
Show answer
Answer C: All of it
A tiedown that is anchored on one side, passes over or around the cargo and is anchored on the other side counts its full working load limit toward the aggregate figure.
-
4. You are moving an oversized load under a permit that requires a pilot vehicle. What is the pilot vehicle there to do?
Show answer
Answer B: Warn other traffic and check the route ahead for clearances and hazards
Escort or pilot vehicles warn approaching traffic and scout the route for low bridges, narrow spots and other hazards that a wide or long load cannot pass.
-
5. Which of these is NOT on the federal list of parts and accessories the driver must be satisfied are in good working order before driving?
Show answer
Answer D: The seat cushion upholstery
The federal pre-trip rule names brakes, steering, lights and reflectors, tires, horn, wipers, mirrors, coupling devices, wheels and rims, and emergency equipment; seat upholstery is not on that list.
-
6. You have backed into the same loading bay every week for a year. How often should you still get out and walk to the rear before backing?
Show answer
Answer D: Every time, since the area can change while you are away from it
A familiar space is no guarantee; vehicles, pallets, people and overhead obstructions appear between one visit and the next, so you check on every occasion.
-
7. Besides the hours when the law requires them, when should headlights be switched on?
Show answer
Answer A: Any time visibility is poor, such as in rain, fog or at dusk
Headlights are used to be seen as much as to see, so they belong on whenever light or weather makes the vehicle harder to spot.
-
8. How many questions are on the general knowledge test for any Iowa CDL class, and how many may be missed?
Show answer
Answer B: 50 questions, 10 may be missed
The Iowa DOT CDL Testing page lists the general knowledge test for any CDL as 50 questions with 10 allowed misses.
-
9. What actually lowers the amount of alcohol in the bloodstream?
Show answer
Answer B: Time
The liver removes alcohol at a fixed rate, so nothing but the passage of time reduces blood alcohol concentration.
-
10. Regular mirror checks during a long trip can reveal which developing problem?
Show answer
Answer D: Smoke coming from a tire or from a wheel
Overheating tires, wheel bearings and brakes usually show as smoke long before anything appears on the dash, and mirrors are where a driver sees it.
-
11. A fire starts in the cargo area of a van trailer. Why should you keep the doors closed until firefighters arrive?
Show answer
Answer D: Opening the doors lets in air that feeds the fire
A fire in a closed van is starved of oxygen; opening the doors gives it the air it needs to flare up.
-
12. What should you check about the fuel tank during the walkaround?
Show answer
Answer A: That it is securely mounted, the cap is on tight and there are no leaks
A loose tank or a missing cap can spill fuel, and any fuel leak is a fire hazard that makes the vehicle unsafe to drive.
-
13. What is the correct order for a basic double clutch upshift?
Show answer
Answer B: Release the accelerator and push the clutch, shift to neutral, release the clutch, let engine speed drop, push the clutch again and shift to the higher gear
Double clutching passes through neutral with the clutch released so engine speed can drop to match the next gear before it is engaged.
-
14. What is the driver responsible for when a load is covered with a tarp?
Show answer
Answer C: Fastening it so it cannot flap free, block a mirror, or come off in the wind
A tarp that works loose can tear away, block the driver view or the view of others, and become a hazard for the traffic behind.
-
15. A fire has started in the vehicle. How should the extinguisher be used?
Show answer
Answer B: Stay as far back as the reach of the extinguisher allows, stand upwind, and aim at the base of the fire
Aiming at the base attacks what is actually burning, and staying upwind and well back protects the driver from heat, smoke and the flames themselves.
-
16. You stop to check the load. Which set of things are you looking at?
Show answer
Answer C: Tight tiedowns, cargo that has not moved, secure doors and tarps still fastened
A cargo check covers the load and everything holding it: whether it has shifted, whether the devices are still tight, and whether doors and covers are still closed and fastened.
-
17. A strap is a little too long, so a driver ties a knot in it to take up the slack. Is that acceptable?
Show answer
Answer C: No, tiedowns must not contain knots
A knot destroys the rated strength of a tiedown, so the rules do not allow knotted securement devices; the excess is taken up by the winch or ratchet instead.
-
18. What do you check about the fire extinguisher during the pre-trip?
Show answer
Answer C: That it is securely mounted, charged and that you know how to operate it
An extinguisher must be held in its bracket, show a charged gauge and be understood by the driver, because a fire leaves no time to learn.
-
19. Why must exhaust components be checked for contact with other parts of the vehicle?
Show answer
Answer B: Hot exhaust parts touching fuel lines, tires or wiring can start a fire
Exhaust pipes run hot enough to ignite fuel and melt insulation, so they must be kept clear of the fuel system, the tires and the electrical harness.
-
20. A company mechanic serviced your truck this morning and signed the work order. Do you still have to inspect the vehicle?
Show answer
Answer B: Yes, the driver is still responsible for being satisfied the vehicle is safe
Shop work does not transfer the duty; the driver who takes the vehicle out remains responsible for being satisfied it is in safe operating condition.
-
21. What does the tachometer on the dashboard of a heavy truck show?
Show answer
Answer D: How fast the engine is turning, in revolutions per minute
The tachometer reads engine speed in rpm, which is what a driver uses to judge shift points in a vehicle with a manual transmission.
-
22. How are the extra gears of a multi-speed rear axle or auxiliary transmission usually controlled?
Show answer
Answer D: With a selector knob or switch on the gearshift lever of the main transmission
A range selector on the shift lever lets the driver choose the extra gear range while shifting the main transmission.
-
23. Why should both outside mirrors be checked over and over while backing?
Show answer
Answer B: Each mirror covers only part of the path and neither covers the blind spots, so people and objects can appear without warning
Working both mirrors in turn is the only way to follow the whole path of a vehicle you cannot see behind.
-
24. You are driving past a park where children are playing close to the curb. What is the correct assumption?
Show answer
Answer A: A child may run into the street without looking
Children act on impulse and do not judge traffic well, so a driver has to expect one to enter the road and slow down in advance.
-
25. The temperature is around freezing and the road looks wet. What is a practical way to tell whether it is icy?
Show answer
Answer C: Check for ice building up on the mirrors, antenna or the front of the vehicle
Ice that forms on the mirror, antenna or windshield is a warning that the road surface is freezing too, and black ice can look like a wet road.
-
26. You are inspecting the vehicle alone and need to confirm that the stop lights work. Which method is correct?
Show answer
Answer A: Have a helper press the brake pedal, or apply the brake in a way that keeps it on while you check from outside
Stop lights are checked from outside the vehicle while the brakes are applied, so a helper or a brake held on is needed.
-
27. Which step of the seven-step inspection method comes immediately after checking the engine compartment?
Show answer
Answer D: Start the engine and inspect the inside of the cab
Once the hood is closed the driver moves to the driver seat, starts the engine and checks gauges, controls and warning devices before going any further.
-
28. What does gross vehicle weight mean, as opposed to gross vehicle weight rating?
Show answer
Answer B: The actual weight of the single vehicle plus everything it is carrying
Gross vehicle weight is what the vehicle actually weighs at that moment; the rating is the maximum the manufacturer allows it to weigh.
-
29. A sign before a long descent shows 6 percent. What does that number tell you?
Show answer
Answer A: How steep the grade ahead is
Percent grade is the drop in feet for every hundred feet of road, so the higher the number the faster speed will build and the lower the gear you need.
-
30. What must be checked about the cargo doors and any tarpaulin before a trip?
Show answer
Answer B: That the doors are closed and latched and that any tarp is tied down securely
An unlatched door or a loose tarp can swing open or tear free at speed, spilling cargo or blocking the view of the traffic behind you.
-
31. When should the horn of a commercial vehicle be used?
Show answer
Answer C: Only when it is needed to avoid a crash
An air horn is loud enough to startle other road users, so it is a warning device rather than a way to comment on other drivers.
-
32. You are making a right turn and cannot complete it without swinging into the oncoming lane. An oncoming car is approaching. What should you do?
Show answer
Answer A: Wait and let the oncoming vehicle pass before completing the turn, and do not back up
The oncoming vehicle has the lane; backing up in traffic is dangerous, so hold your position and finish the turn once the way is clear.
-
33. Besides being uncomfortable, what can a series of hard, jerky brake applications do to a loaded combination?
Show answer
Answer A: Shift the load and push the trailer out of line behind the tractor
Sudden, uneven braking can move cargo forward and upset the alignment of a trailer, which is why stops should be made smoothly.
-
34. On a one way street or a divided highway, where are the warning devices placed?
Show answer
Answer B: About 10 feet, 100 feet and 200 feet back toward the approaching traffic
When traffic can only come from one side, all three devices are spread out behind the vehicle to give approaching drivers a longer warning.
-
35. You are stopped in traffic on a steep upgrade behind another truck. How much space should you leave in front?
Show answer
Answer A: Enough that you can pull away without rolling back into the vehicle behind you
Room ahead lets you get moving smoothly on a grade instead of having to hold the vehicle perfectly still or roll back toward the traffic behind.
-
36. Which exhaust system condition must be reported as a defect?
Show answer
Answer B: A section repaired by wrapping tape or patching material around the pipe
Exhaust parts may not be patched with wrap or tape, because the repair does not contain the gas or the heat and it fails quickly in service.
-
37. Why must tiedowns be rechecked during a trip even when they were tight at the start?
Show answer
Answer C: Road vibration and cargo movement can loosen them as the miles go by
Straps and chains settle and loosen as the vehicle bounces and the cargo shifts slightly, so the load must be rechecked at the required intervals.
-
38. On a tractor with a sliding fifth wheel, what does moving the fifth wheel forward do?
Show answer
Answer A: Puts more of the trailer weight onto the steering axle
Moving the coupling point forward transfers weight from the drive axles to the steering axle, which is how a driver corrects a drive axle that is over the limit.
-
39. When is a road surface usually most slippery during a rain shower?
Show answer
Answer A: Just after the rain starts, when water mixes with oil and dirt on the surface
The first rain lifts oil and dust into a slick film that has not yet been washed away, so the road is more slippery than it will be later.
-
40. When should a driver select the gear for a long, steep downgrade?
Show answer
Answer B: Before starting down the grade
The low gear has to be chosen before the descent, because a heavy vehicle gaining speed may refuse to shift down at all.
-
41. What is the first step of the standard seven-step vehicle inspection?
Show answer
Answer C: A general overview of the vehicle, including the last inspection report
The routine opens with a walk-up overview of the vehicle and a review of the previous inspection report so known defects are addressed first.
-
42. What condition should the fifth wheel be in before you back under a trailer?
Show answer
Answer C: Jaws open, plate greased, and the fifth wheel tilted down toward the rear
The jaws have to be open to take the kingpin, the plate must be lubricated to prevent hard steering, and the fifth wheel is tilted down at the rear so the trailer apron can ride up onto it.
-
43. You have a part load that fills only a third of a long trailer. How should it be placed?
Show answer
Answer C: Spread out and centerd side to side, so the weight sits over the axles
A part load is spread over as much of the floor as possible and kept centerd, so no axle is overloaded and the vehicle stays balanced from side to side.
-
44. Some commodities have their own detailed securement rules on top of the general ones. Which list is made up of such commodities?
Show answer
Answer C: Logs, metal coils, paper rolls, concrete pipe and crushed vehicles
The cargo securement rules add specific requirements for particular commodities, including logs, dressed lumber, metal coils, paper rolls, concrete pipe, intermodal containers, vehicles, crushed cars, roll on containers and large boulders.
-
45. Which document must be available to show that the annual inspection was carried out?
Show answer
Answer C: The inspection report or a copy of it, or a decal displayed on the vehicle
Proof of the periodic inspection travels with the vehicle, either as the report itself or as the decal fixed where an inspector can see it.
-
46. You are pulling away from the curb after a delivery. Why is a mirror check needed first?
Show answer
Answer B: A cyclist or a vehicle may be coming up alongside you
Traffic and cyclists can arrive alongside a parked vehicle at any moment, so the mirrors must be checked immediately before pulling out.
-
47. How is a shipping container normally secured when it is carried on a special container chassis?
Show answer
Answer B: With its own locking devices that attach the container directly to the chassis frame
Containers built for rail or ship transport have locking corners that fasten to a matching chassis; a container carried on a plain flatbed must be secured like any other cargo.
-
48. When should a lower gear be selected for a long downgrade?
Show answer
Answer D: Before you start down the hill
The gear is chosen at the top, while speed is still low, because a heavy vehicle already rolling fast may not go into a lower gear at all.
-
49. At what time of day do drowsy driving crashes occur most often?
Show answer
Answer A: Between midnight and 6 a.m.
The body clock makes people sleepiest in the early morning hours, which is when most fatigue-related crashes happen.
-
50. You are loading a flatbed that has no sides or bulkheads. How must the cargo be held?
Show answer
Answer D: By tiedowns, blocking or bracing, since there are no walls to keep it from shifting or falling off
Open decks depend entirely on securement devices; every article must be tied down or otherwise immobilized so it cannot move, spill or fall.